Fiberglass Series - Streetview Single Set

• Sturdy cast aluminum brackets.
• Rigid 1.1/4" diameter fiberglass arms, lighter and stronger than aluminum.
• Aluminum reinforced extremity to safely tighten banner arm in bracket.

Fiberglass Series - Streetview Twin Set

• Sturdy cast aluminum brackets.
• Rigid 1.1/4" diameter fiberglass arms, lighter and stronger than aluminum.
• Aluminum reinforced extremity to safely tighten banner arm in bracket.

Aluminum Series - Avenue Banner Mounting Kit

This kit is everything that you need to mount 1 avenue banner to an in-ground light pole or street pole. It contains 2 brackets, 2 aluminum arms, and 4 bands. Crossbars are fabricated from 1.5" outside diameter clear anodized aluminum poles with end caps for a finished look. Ideal for round poles. For square poles we suggest the U-bolts below. Parts are available separately below.

Aluminum Series - Double-Avenue Banner Mounting Kit

This kit is everything that you need to mount 2 avenue banners directly across from each other to an in-ground light pole or street pole. It contains 2 double brackets, 2 aluminum arms, and 4 bands. Crossbars are fabricated from 1.5" outside diameter clear anodized aluminum poles with end caps for a finished look. Ideal for round poles. For square poles we suggest the U-bolts below. Parts are available separately below.

Aluminum Series - Brackets Only

These are replacement parts for the kits above. It is a single aluminum bracket with NO pole or other hardware. Each bracket holds a 1.5" diameter pole.

Aluminum Series - Poles Only

These are replacement parts for the kits above. It is a single aluminum banner pole, 1.5" diameter with a wall thickness of .125". When ordering replacements, be sure to get the right length pole. Typically 6" wider than you single banner, or if hanging double banners as above, double the with of 1 banner and add 12" for the length of the pole. Caps and other hardware NOT included.

Aluminum Series - Plastic End Caps

For the end of your 1.5" pole.

U-Bolts for Square Poles

Each U-Bolt comes complete with washers, lock washers, nuts & back plate. Two U-Bolts per bracket are required.

Ornament Adapter

This aluminum adapter must be installed at the factory & will accept any ornament with a spindle threading of 1/2"-13NC. Priced per adapter.

Bands Only / Stainless Steel Mounting Strap (No assembly required)

Complete Quick-Release bands. Metal banding with adjustment screw. Each ave. bracket requires 2 bands.

Banding Parts (Assembly required)

The most economical way to install large quantities of banners or for installations requiring different lenghts of banding.

Email cheryl@gettysburgflag.com for a quote on custom colored banding and buckles to match your light poles or existing hardware.